Plot style table multi selection
Mauro Murta
07 Apr 2017
Hello everybody
When I need to change the plot styles, I have to select them one by one. If I press Shift the multi selection does not work, as it does on other softwares like Draftsight. See picture.
Is there any other way to multi select the styles or, if not, will it be a next improvement of the software?
This problem had been raised by a nanoCAD user in 2012. See link below.
http://forum.nanocad...editor-problem/
Thank you
Mauro Murta
When I need to change the plot styles, I have to select them one by one. If I press Shift the multi selection does not work, as it does on other softwares like Draftsight. See picture.
Is there any other way to multi select the styles or, if not, will it be a next improvement of the software?
This problem had been raised by a nanoCAD user in 2012. See link below.
http://forum.nanocad...editor-problem/
Thank you
Mauro Murta
Mauro Murta
07 Apr 2017
Thank you!
Hope it will be fixed also on the next free versions.
Hope it will be fixed also on the next free versions.
