Problem with selection preview.
Nayara Ferreira
17 Jan 2017
Selection preview, only works if you select and then execute a command.
If you run a command to then select it no longer works.
Any solution?
If you run a command to then select it no longer works.
Any solution?
Hellen_V
18 Jan 2017
Hello Nayara,
turn on the "Keep pre-selection after modification" in Options in nanoCAD Plus:
turn on the "Keep pre-selection after modification" in Options in nanoCAD Plus:
Nayara Ferreira
19 Jan 2017
Example:
I create a line.
I type the Copy or Move command
Select and move and end the command.
But I want to move or copy again with the same selection
Re-enter the Copy or Move command
But now I give Preview
But it does not select correctly.
Only works in the following order
I create a line.
I select
I type the Copy or Move command
Move and end the command.
That way when I re-type the Copy or Move and Preview command
It correctly selects the last selection.
But I need to remember that if I want to use the preview I have to select before
I create a line.
I type the Copy or Move command
Select and move and end the command.
But I want to move or copy again with the same selection
Re-enter the Copy or Move command
But now I give Preview
But it does not select correctly.
Only works in the following order
I create a line.
I select
I type the Copy or Move command
Move and end the command.
That way when I re-type the Copy or Move and Preview command
It correctly selects the last selection.
But I need to remember that if I want to use the preview I have to select before
