Selection preview, only works if you select and then execute a command.
If you run a command to then select it no longer works.
Any solution?
1
Problem with selection preview.
Started by Nayara Ferreira, Jan 17 2017 09:46 AM
4 replies to this topic
#1
Posted 17 January 2017 - 09:46 AM
#2
#3
Posted 19 January 2017 - 12:16 PM
I did this did not work.
#4
Posted 19 January 2017 - 01:05 PM
what commands do you run?
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
#5
Posted 19 January 2017 - 01:29 PM
Example:
I create a line.
I type the Copy or Move command
Select and move and end the command.
But I want to move or copy again with the same selection
Re-enter the Copy or Move command
But now I give Preview
But it does not select correctly.
Only works in the following order
I create a line.
I select
I type the Copy or Move command
Move and end the command.
That way when I re-type the Copy or Move and Preview command
It correctly selects the last selection.
But I need to remember that if I want to use the preview I have to select before
I create a line.
I type the Copy or Move command
Select and move and end the command.
But I want to move or copy again with the same selection
Re-enter the Copy or Move command
But now I give Preview
But it does not select correctly.
Only works in the following order
I create a line.
I select
I type the Copy or Move command
Move and end the command.
That way when I re-type the Copy or Move and Preview command
It correctly selects the last selection.
But I need to remember that if I want to use the preview I have to select before
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users