mouse wheel scroll
Iosif Schlahetka
20 Oct 2016
Hello,
I have nanoCAD 5.0.2520.1471. The zooming with the mouse wheel, works just one time after I open a dwg, after the wheel mouse makes just scrolling. If I close the dwg and reopen it the same think happens.
I have a Logitech M325 wireless mouse. I installed a software from Logitech (setpoint) where I configured the Forward/Back buttons to do zoom In/out for nanoCAD application and the buttons are working just one time (the first time) and after they do scrolling.
Can you advice me what to do?
Thank you!
I have nanoCAD 5.0.2520.1471. The zooming with the mouse wheel, works just one time after I open a dwg, after the wheel mouse makes just scrolling. If I close the dwg and reopen it the same think happens.
I have a Logitech M325 wireless mouse. I installed a software from Logitech (setpoint) where I configured the Forward/Back buttons to do zoom In/out for nanoCAD application and the buttons are working just one time (the first time) and after they do scrolling.
Can you advice me what to do?
Thank you!
SevaM
27 Oct 2016
Hello Iosif,
not sure for wireless Logitech, I am using Logitech M-U0007 wired mouse and Microsoft wireless 4000 mouse with nanocad without problems, but I am not using special mouse software. If you not use setpoint software - are mouse wheel operations correct?
I'll try to install Logitech software and check, can it works with wired mouse.
not sure for wireless Logitech, I am using Logitech M-U0007 wired mouse and Microsoft wireless 4000 mouse with nanocad without problems, but I am not using special mouse software. If you not use setpoint software - are mouse wheel operations correct?
I'll try to install Logitech software and check, can it works with wired mouse.
Iosif Schlahetka
08 Nov 2016
Hello SevaM,
I have the same behavior with a wired mouse (A4-X7).
I installed the logitech software after I saw this behavior. I hoped that if I configure in the software the Forward/Back buttons to do zoom In/out it will make zoom In/out also in nanoCAD, but is not zooming.
I have the same behavior with a wired mouse (A4-X7).
I installed the logitech software after I saw this behavior. I hoped that if I configure in the software the Forward/Back buttons to do zoom In/out it will make zoom In/out also in nanoCAD, but is not zooming.
