nanoCAD forum

NanoCAD 7 Plus: when trying to bhatch, I am getting a fatal error when I attempt to 'Add: pick points.' Any thoughts?

nanoCAD Plus 7 can't hatch boundary (region), use nanoCAD Plus 8.
But, anyway, it should not give you fatal error... Please, send me your file with fatal boundary.

Thanks. Just upgraded to 8. Will follow up if it is still a problem.

OttenLA, on 01 October 2016 - 03:18 PM, said:

Send me your file, please. You can attach it here or send to Support Center support@nanocad.com