Joining polylines to fillets, arcs and cur...
Ray 29 May 2015
I have a problem joining straight polylines with fillets, curves and arcs.
Very often, after exploding a polyline consisting of curves and straight polylines, I am unable to select all and re-join them using pedit -> multiple -> convert (Y) -> join.
Instead, I have to re-fillet the necessary curves to join the entire polyline. I do not face this problem for chamfers. AutoCAD also does not have this issue.
Am I the only one facing this problem?
Very often, after exploding a polyline consisting of curves and straight polylines, I am unable to select all and re-join them using pedit -> multiple -> convert (Y) -> join.
Instead, I have to re-fillet the necessary curves to join the entire polyline. I do not face this problem for chamfers. AutoCAD also does not have this issue.
Am I the only one facing this problem?
Hellen_V 29 May 2015
Hello Ray,
try to do the following:
1. Select one line or arc
2. Call PEDIT - Yes - Join, then select all lines, Enter, Enter.
try to do the following:
1. Select one line or arc
2. Call PEDIT - Yes - Join, then select all lines, Enter, Enter.