ucs 3 point
Mark Pigott
19 Sep 2014
is there a way to define a ucs via 3 points?
i do not see this in the ucs menu.
thanks
i do not see this in the ucs menu.
thanks
Hellen_V
22 Sep 2014
Hello Mark,
call UCS command, specify start point of UCS, then a point on the positive ray of the X axis, then a point on the positive ray of the Y axis in the XY plane.
call UCS command, specify start point of UCS, then a point on the positive ray of the X axis, then a point on the positive ray of the Y axis in the XY plane.
Mark Pigott
22 Sep 2014
Thanks.
Another question.
I can not use object snap to Polyface mesh for the "mid point", only end point.
Is this normal behaviour?
Another question.
I can not use object snap to Polyface mesh for the "mid point", only end point.
Is this normal behaviour?
Aidan Collingwood
16 Oct 2019
Hellen_V, on 22 September 2014 - 06:25 AM, said:
Hello Mark,
call UCS command, specify start point of UCS, then a point on the positive ray of the X axis, then a point on the positive ray of the Y axis in the XY plane.
call UCS command, specify start point of UCS, then a point on the positive ray of the X axis, then a point on the positive ray of the Y axis in the XY plane.
Hellen_V, I use Nanocad 5 and this does not seem to work for me. I always used it in Autocad so I should be able to follow your instructions as they seem to be the same as in Autocad? To clarify, I am trying to rotate the modelspace so that I can draw four elevations arranged around the plan with the elevations always below the plan on the screen. Does this command not work in Nanocad 5?
