Create new dimension DIMSCALE
Nayara Ferreira
10 Jun 2014
I'm changing the DIMSCALE, but when I create a new dimension always comes 1:1.
I've tried changing the "Dimension Style Manager" but also new dimensions do not obey.
I've tried changing the "Dimension Style Manager" but also new dimensions do not obey.
Hellen_V
11 Jun 2014
Hello Nayara,
if you need to change the scale of dimension, then use Symbol scale from status bar or use Scale in Inspector.
if you need to change the scale of dimension, then use Symbol scale from status bar or use Scale in Inspector.
Hellen_V
11 Jun 2014
There was bug with Dimension Style manager, will be fixed in new version.
Nayara Ferreira
15 Sep 2015
Hello!
I use NanoCAD 5.0, today I downloaded version 7.0 to see if the problem had been resolved, but the scale is still always 1:1 in modelspace.
I use NanoCAD 5.0, today I downloaded version 7.0 to see if the problem had been resolved, but the scale is still always 1:1 in modelspace.
Hellen_V
23 Sep 2015
Nayara Ferreira, on 15 September 2015 - 04:09 PM, said:
Hello!
I use NanoCAD 5.0, today I downloaded version 7.0 to see if the problem had been resolved, but the scale is still always 1:1 in modelspace.
I use NanoCAD 5.0, today I downloaded version 7.0 to see if the problem had been resolved, but the scale is still always 1:1 in modelspace.
Try to do the following:
Open Tools - Advanced settings - Main options tab - Edit - Scale dimensions - No.
After this action DIMSCALE should work normally.
