Turn off snap nearest in command
Rob
05 Feb 2014
Hi,
I was used in autocad to turn on the snaps nearest and perpendicular in a command. This I did by using the command then to type NEA or PER and then the snappoints were added just for this command. After finishing the command those snaps were off again.
Is that also possible in Nanocad?
Hope to hear from you soon
Greetings
Rob
I was used in autocad to turn on the snaps nearest and perpendicular in a command. This I did by using the command then to type NEA or PER and then the snappoints were added just for this command. After finishing the command those snaps were off again.
Is that also possible in Nanocad?
Hope to hear from you soon
Greetings
Rob
Hellen_V
05 Feb 2014
Hello, Rob!
You can use one-time object snap during one of the creation or modifying commands. Open the context menu of one-time object snap with CTRL button pressed and select the required mode. But only one mode can be selected there. When a snap point is selected, one-time object snap switches off.
You can use one-time object snap during one of the creation or modifying commands. Open the context menu of one-time object snap with CTRL button pressed and select the required mode. But only one mode can be selected there. When a snap point is selected, one-time object snap switches off.
