Visual C++ for Nanocad 5.0
Gabriel
30 Nov 2013
I have new install my computer. Big problem with the installation of Nanocad 5.0 with C ++. After many searches I found the link which works for nanocad. The link during the installation did not work for me.
http://npackd.appspo...le/9.0.30729.17
Best regards
Laurent
http://npackd.appspo...le/9.0.30729.17
Best regards
Laurent
SevaM
02 Dec 2013
Hello Laurent,
what Windows version are you using?
Try to download and install VC runtime before installing nanoCAD.
You can find VCRT ( ver 9.0 ) for your Windows on Microsoft web-site - http://support.micro....com/kb/2019667.
Best regards,
Seva.
what Windows version are you using?
Try to download and install VC runtime before installing nanoCAD.
You can find VCRT ( ver 9.0 ) for your Windows on Microsoft web-site - http://support.micro....com/kb/2019667.
Best regards,
Seva.
ISL
02 Dec 2013
The developer's installer that you tried to install did not contain the prerequisites, you can download the full package from http://www.nanocad.com or from ftp://ftp.nanocad.com.
The link to the Visual C++ Runtime was correct at the time it was put into the setup.ini, but Microsoft sometimes updates the runtime under the same url.
To install nanoCAD with the newer runtime, just remove the following section from the setup.ini:
The link to the Visual C++ Runtime was correct at the time it was put into the setup.ini, but Microsoft sometimes updates the runtime under the same url.
To install nanoCAD with the newer runtime, just remove the following section from the setup.ini:
[PreReq2] Name=Microsoft Visual C++ 2008 Redistributable - x86 9.0.30729.17
