Drafting in Architecture -
Chuck Bennett 29 Jun 2023
I am trying to make a floor plan. I've set the units to Architectural and inches.
I make a 5 wide wall and add doors just fine
When I try to add a window it is too large. Changing the width from default 111 to 5 to match the walls leaves funny external lines.
See screen shots attached
Basic 25 long line. Upper dimension uses primary units of Arch and lower is decmal
Door and goofy window on 5 wide wall
I make a 5 wide wall and add doors just fine
When I try to add a window it is too large. Changing the width from default 111 to 5 to match the walls leaves funny external lines.
See screen shots attached
Basic 25 long line. Upper dimension uses primary units of Arch and lower is decmal
Door and goofy window on 5 wide wall
Artemio 29 Jun 2023
Sorry, I can't see any screenshots attached here...
Have you checked symbol scale?
Have you checked symbol scale?
Chuck Bennett 30 Jun 2023
Artemio 30 Jun 2023
Yeah, got it...
Seems like a bug, but I'm not sure.
However, can you, please, try to change "representation" from "normal" to "simple".
You can do it in "properties" panel after window selection.
Then window with width 5 will appears some better, hopefully.
Seems like a bug, but I'm not sure.
However, can you, please, try to change "representation" from "normal" to "simple".
You can do it in "properties" panel after window selection.
Then window with width 5 will appears some better, hopefully.