Loft guides issues
conti_rowland
19 Aug 2022
Hi,
I'm trying to create some complex lofts using plines.
I have 3 guides, one at either end and one in between.
I can get 2 of the guides at a time to be recognised but not all 3 and never both end guides.
I have tried to ensure that every pline has a corresponding geometry - in the sense that each is made of a similar number of curves and lines as I have previously had issues with that in Autocad.
Help please!
Andrew
I'm trying to create some complex lofts using plines.
I have 3 guides, one at either end and one in between.
I can get 2 of the guides at a time to be recognised but not all 3 and never both end guides.
I have tried to ensure that every pline has a corresponding geometry - in the sense that each is made of a similar number of curves and lines as I have previously had issues with that in Autocad.
Help please!
Andrew
Artemio
19 Aug 2022
Hi.
I'm not sure if understand your issue correctly.
To draw precisely there is a good helper: Object snap and Polar tracking.
They can be settled in DSETTINGS dialog window.
If this is not what you need - can you, please, give a little bit more information?
I'm not sure if understand your issue correctly.
To draw precisely there is a good helper: Object snap and Polar tracking.
They can be settled in DSETTINGS dialog window.
If this is not what you need - can you, please, give a little bit more information?
conti_rowland
22 Aug 2022
Hi there,
The issue was that the loft command did not work. The guides were not followed. It returned an error message.
In the end I found a solution by lofting the guides and using my original loft curves as guides!
Thanks
Andrew
The issue was that the loft command did not work. The guides were not followed. It returned an error message.
In the end I found a solution by lofting the guides and using my original loft curves as guides!
Thanks
Andrew
