Hi,
I'm trying to create some complex lofts using plines.
I have 3 guides, one at either end and one in between.
I can get 2 of the guides at a time to be recognised but not all 3 and never both end guides.
I have tried to ensure that every pline has a corresponding geometry - in the sense that each is made of a similar number of curves and lines as I have previously had issues with that in Autocad.
Help please!
Andrew
1
2 replies to this topic
#1
Posted 19 August 2022 - 06:04 AM
#2
Posted 19 August 2022 - 07:33 PM
Hi.
I'm not sure if understand your issue correctly.
To draw precisely there is a good helper: Object snap and Polar tracking.
They can be settled in DSETTINGS dialog window.
If this is not what you need - can you, please, give a little bit more information?
I'm not sure if understand your issue correctly.
To draw precisely there is a good helper: Object snap and Polar tracking.
They can be settled in DSETTINGS dialog window.
If this is not what you need - can you, please, give a little bit more information?
#3
Posted 22 August 2022 - 04:00 AM
Hi there,
The issue was that the loft command did not work. The guides were not followed. It returned an error message.
In the end I found a solution by lofting the guides and using my original loft curves as guides!
Thanks
Andrew
The issue was that the loft command did not work. The guides were not followed. It returned an error message.
In the end I found a solution by lofting the guides and using my original loft curves as guides!
Thanks
Andrew
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users