Best export format for different CAD Software
David_Parker
05 Jul 2022
There are others using my model in autocad but the 3d solids are causing errors.
Was under the impression that I could switch between without problems.
Here is the example in autocad after I have exported from Nanocad:
Is there a way around these issues?
Was under the impression that I could switch between without problems.
Here is the example in autocad after I have exported from Nanocad:
Is there a way around these issues?
Artemio
07 Jul 2022
Hello.
There was something similar, if I'm not mistaken.
https://forum.nanoca..._4924#entry4924
Do you have "2D wireframe" in "Visual Styles" when see this lines?
Is it permanent, or temporary issue?
There was something similar, if I'm not mistaken.
https://forum.nanoca..._4924#entry4924
Do you have "2D wireframe" in "Visual Styles" when see this lines?
Is it permanent, or temporary issue?
David_Parker
09 Jul 2022
Permanent Issue and all visual styles, but not in nanocad - only when I tryed to open in Autocad.
It was related to the sweep command because after I repeated the model using extrusions it fixed the problem.
I am however experiencing another problem with the sweep tool. This happened in Nanocad when I tried to mirror a handrail on my stairs. I fixed it by mirroring my polyline path instead and recreated the railing seperately.
The problem has reappeared when I open in autocad and strangely this time it is on both the original handrail and the repeated. This leads me to think the issue was in the original sweep model in nanocad but only showed in the mirror.
Autocad has shown both errors.
Reason I am jumping between the two programs is drafting stanards - I haven't set up for Nanocad and it doesn't translate from my autocad template properly. Not a big issue , just need time to integrate but it's a problem switching between programs is causing model problems because I have colleagues working remotely using autocad to open these models.
For now I will repeat the sweeps in autocad. I hope these get resolved, I enjoy the uncluttered ribbons of nanocad and it has much better performance (very smooth) .
It was related to the sweep command because after I repeated the model using extrusions it fixed the problem.
I am however experiencing another problem with the sweep tool. This happened in Nanocad when I tried to mirror a handrail on my stairs. I fixed it by mirroring my polyline path instead and recreated the railing seperately.
The problem has reappeared when I open in autocad and strangely this time it is on both the original handrail and the repeated. This leads me to think the issue was in the original sweep model in nanocad but only showed in the mirror.
Autocad has shown both errors.
Reason I am jumping between the two programs is drafting stanards - I haven't set up for Nanocad and it doesn't translate from my autocad template properly. Not a big issue , just need time to integrate but it's a problem switching between programs is causing model problems because I have colleagues working remotely using autocad to open these models.
For now I will repeat the sweeps in autocad. I hope these get resolved, I enjoy the uncluttered ribbons of nanocad and it has much better performance (very smooth) .
