Jump to content


display the m2 (area) of an object

area m2

6 replies to this topic

#1 opti

    Newbie

  • Members
  • Pip
  • 3 posts

Posted 03 May 2022 - 06:55 AM

Hi everyone, sorry my English, is still from school. I have Nanocad 5, how can I display the m2 (area) of an object that I do not always have to measure myself? For example, I looked at a square under Properties and to my amazement there is no area listed there? Thank you!

#2 pguimber

    Advanced Member

  • Members
  • PipPipPip
  • 387 posts
  • LocationFrance - Maine et Loire

Posted 03 May 2022 - 06:58 AM

une image ou un fichier pour vérifier ?

#3 pguimber

    Advanced Member

  • Members
  • PipPipPip
  • 387 posts
  • LocationFrance - Maine et Loire

Posted 03 May 2022 - 07:03 AM

hello,
simple square or block ?

#4 opti

    Newbie

  • Members
  • Pip
  • 3 posts

Posted 03 May 2022 - 08:52 AM

View Postpguimber, on 03 May 2022 - 07:03 AM, said:

hello,
simple square or block ?

Unfortunately, I do not know the technical terms in English, I am german speaking. I draw a square or a rectangle with Nanocad and want to know the area of it. When I highlight the object and go to Properties, I don't find the area displayed anywhere. I used to use Autocad, there is under properties the surface, as I remember?

#5 pguimber

    Advanced Member

  • Members
  • PipPipPip
  • 387 posts
  • LocationFrance - Maine et Loire

Posted 03 May 2022 - 10:27 AM

Ok,
sur ma version 5 j'obtiens ceci ...
Bei meiner Version 5 bekomme ich das ...

Attached Thumbnails

  • Attached Image: Capture.JPG


#6 opti

    Newbie

  • Members
  • Pip
  • 3 posts

Posted 03 May 2022 - 12:42 PM

View Postpguimber, on 03 May 2022 - 10:27 AM, said:

Ok,
sur ma version 5 j'obtiens ceci ...
Bei meiner Version 5 bekomme ich das ...
ouii, maintenant ca fonctionne :-) Merci merci, je ne sais pas.... :-)

#7 JosephGibson

    Newbie

  • Members
  • Pip
  • 1 posts

Posted 07 January 2023 - 10:32 PM

View Postopti, on 03 May 2022 - 06:55 AM, said:

Hi everyone, sorry my English, is still from school. I have Nanocad 5, how can I display the m2 (area) of an object that I do not always have to measure myself? For example, I looked at a square under Properties and to my amazement there is no area listed there? Thank you!

"AREA" command Calculates the area and perimeter of area, closed objects & polylines. autocad command.You can obtain measurements by selecting an object, or by specifying points to define what you want to measure. The area and perimeter of the specified object are displayed at the Command prompt and in the tooltip.






1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users