How to set the default spline type as cont...
memeac2006user
11 Nov 2020
I have been used to CV splines in my past experiences. In this software I have to refine every spline from fit to CV to suit my needs, I think that is too much work. Is there a way to set the default spline type to the control vertices type?
Kreator
14 Nov 2020
Hi.
In NC v20 you can use 2 separate commands to start CV or fit splines, or change there type in properties window after you finish spline.
In NC v20 you can use 2 separate commands to start CV or fit splines, or change there type in properties window after you finish spline.
