_from command (Relative coordinate)
Claudio Bogado
01 Oct 2020
Hi.
In AutoCAD there is the _from command to input a relative coordinate. I did not find this command in nanoCAD 5. I did not find the .x, .y, etc. filters either.
Is there a way in nanoCAD 5 to calculate relative coordinates?
In AutoCAD there is the _from command to input a relative coordinate. I did not find this command in nanoCAD 5. I did not find the .x, .y, etc. filters either.
Is there a way in nanoCAD 5 to calculate relative coordinates?
Hellen_V
02 Oct 2020
Hi,
use @ symbol to input a relative coordinates.
.x, xy filters are not available in nanoCAD 5.
use @ symbol to input a relative coordinates.
.x, xy filters are not available in nanoCAD 5.
Claudio Bogado
08 Oct 2020
Hellen_V, on 02 October 2020 - 10:56 AM, said:
Hi,
use @ symbol to input a relative coordinates.
.x, xy filters are not available in nanoCAD 5.
use @ symbol to input a relative coordinates.
.x, xy filters are not available in nanoCAD 5.
I am referring to this command modifier.
