Input imperial units
lucca 22 Sep 2020
Hello,
Please indicate how to input imperial units
Such as 1'-2 5/8"
I am trying to draw a line but the fraction of inches doesn't allow.
Units are already in Architectural and insertion scale Inches
Please indicate how to input imperial units
Such as 1'-2 5/8"
I am trying to draw a line but the fraction of inches doesn't allow.
Units are already in Architectural and insertion scale Inches
Hellen_V 23 Sep 2020
Hi,
Did you set Architectural units in UNITS dialog for current drawing? What version of nanoCAD do you use? Where do you try to input imperial units?
Did you set Architectural units in UNITS dialog for current drawing? What version of nanoCAD do you use? Where do you try to input imperial units?
Mark Pigott 09 Sep 2021
Enter in this syntax.
assuming both Units and Dimstyle are set to architectural mode.
8'4-1/2
no spaces.
please note the fractional scale does not work in Nanocad 5.
assuming both Units and Dimstyle are set to architectural mode.
8'4-1/2
no spaces.
please note the fractional scale does not work in Nanocad 5.
Ian Wells 19 Sep 2022
I found that using a dash (a space won't work) creates bazaar outputs. Instead, this has worked for me.
For 5 7/16"
Enter: 5+7/16
For 5 7/16"
Enter: 5+7/16