Trimming Two-Point Rectangle
Evris Mitchell 18 Sep 2020
So guys. Doesn't NanoCAD allow us to trim rectangles? I select the cutting edges, right-click, attempt to select the side to cut and nothing happens. The process works fine with trimming lines and polylines. But when I try with rectangles, the side where I begin my two-point rectangle won't trim while the other sides trim. Very weird!
Miguel 25 Oct 2020
I have the same problem.
I created a rectangle and an offset. When trying to trim it, the inner line (offset) is trimmed but the outerline is not.
It is just my first day of trying NanoCAD, so I wonder what else can I do to investigate the problem or what am I doing wrong...
Edit: Strangely enough, I created a new rectangle and an offset to it and I managed to trim that one. Undortunantely, it looks like we cannot paste pictures in here, so I cannot show both situations. I will move into a new rectangle and delete the one that does not work, but I wonder if this may happen again...
I created a rectangle and an offset. When trying to trim it, the inner line (offset) is trimmed but the outerline is not.
It is just my first day of trying NanoCAD, so I wonder what else can I do to investigate the problem or what am I doing wrong...
Edit: Strangely enough, I created a new rectangle and an offset to it and I managed to trim that one. Undortunantely, it looks like we cannot paste pictures in here, so I cannot show both situations. I will move into a new rectangle and delete the one that does not work, but I wonder if this may happen again...
Hellen_V 29 Oct 2020
Hi,
do you use nanoCAD 5? It can have some problems with Trim, try nanoCAD Plus.
do you use nanoCAD 5? It can have some problems with Trim, try nanoCAD Plus.