So guys. Doesn't NanoCAD allow us to trim rectangles? I select the cutting edges, right-click, attempt to select the side to cut and nothing happens. The process works fine with trimming lines and polylines. But when I try with rectangles, the side where I begin my two-point rectangle won't trim while the other sides trim. Very weird!
1
Trimming Two-Point Rectangle
Started by Evris Mitchell, Sep 18 2020 03:12 AM
3 replies to this topic
#1
Posted 18 September 2020 - 03:12 AM
#2
Posted 18 September 2020 - 08:12 AM
Yes ! i can't reproduce this problem !
#3
Posted 25 October 2020 - 09:57 AM
I have the same problem.
I created a rectangle and an offset. When trying to trim it, the inner line (offset) is trimmed but the outerline is not.
It is just my first day of trying NanoCAD, so I wonder what else can I do to investigate the problem or what am I doing wrong...
Edit: Strangely enough, I created a new rectangle and an offset to it and I managed to trim that one. Undortunantely, it looks like we cannot paste pictures in here, so I cannot show both situations. I will move into a new rectangle and delete the one that does not work, but I wonder if this may happen again...
I created a rectangle and an offset. When trying to trim it, the inner line (offset) is trimmed but the outerline is not.
It is just my first day of trying NanoCAD, so I wonder what else can I do to investigate the problem or what am I doing wrong...
Edit: Strangely enough, I created a new rectangle and an offset to it and I managed to trim that one. Undortunantely, it looks like we cannot paste pictures in here, so I cannot show both situations. I will move into a new rectangle and delete the one that does not work, but I wonder if this may happen again...
#4
Posted 29 October 2020 - 03:23 PM
Hi,
do you use nanoCAD 5? It can have some problems with Trim, try nanoCAD Plus.
do you use nanoCAD 5? It can have some problems with Trim, try nanoCAD Plus.
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users