thicker lines wont trim well
Wim_S 17 Jul 2020
lines of different thickness and that are perpendicular to each other are not trimmed properly
see picture
how can I ensure that the lines fit nicely?
(translated by Google Translate)
see picture
how can I ensure that the lines fit nicely?
(translated by Google Translate)
pguimber 18 Jul 2020
Hello,
it is a question of display quality, normally in printing it should not be seen.
Thick lines are displayed with rectangular ends ....
c'est une question de qualité d'affichage, normalement à l'impression cela ne doit pas se voir.
Les lignes épaisses sont affichées avec des bouts rectangulaires....
Best regards
it is a question of display quality, normally in printing it should not be seen.
Thick lines are displayed with rectangular ends ....
c'est une question de qualité d'affichage, normalement à l'impression cela ne doit pas se voir.
Les lignes épaisses sont affichées avec des bouts rectangulaires....
Best regards
pguimber 20 Jul 2020
Ok,i see !
but it's same in other CAO.
Otherwise it is necessary to make hatching in double lines ... or wipeout
but it's same in other CAO.
Otherwise it is necessary to make hatching in double lines ... or wipeout