paper space scaling issue
nolongat
02 May 2020
my daughter just started using nanocad free version
in paper space when in a view port mode why is the scaling stuck at 1:1 and not changing to what is being shown as you are zooming in or out and not able to adjust to a specific scale
this might have been noted in previous topic
in paper space when in a view port mode why is the scaling stuck at 1:1 and not changing to what is being shown as you are zooming in or out and not able to adjust to a specific scale
this might have been noted in previous topic
pguimber
03 May 2020
Hello,
check, in paper space, if the window is locked (in the properties - right click on the frame).
Regards
Patrick
check, in paper space, if the window is locked (in the properties - right click on the frame).
Regards
Patrick
Kreator
03 May 2020
Hello.
Exit the viewport and check its properties (Ctrl+1) - Locked property should be set to Off.
Exit the viewport and check its properties (Ctrl+1) - Locked property should be set to Off.
