nanoCAD forum

I start to use nanocad for drawing.

I saw that circle are plot as polygon as output PDF is not clear.
I have some logo and the result in PDF is not clean.

Here is an example of what I get:

Is it a way to improve the output ?

Thanks for your support

Hello,
if you use the pdf printer of nanocad you can also use other pdf printer , Pdfcreator and similar. what résult ?

I done it with Bullzip printer (it was the only PDF printer to have ARCHD format - ie 36x24 po).

Is it possible to add this format to the internal PDF printer (I tried but I failed) ? If is it possible I would be able to test on other PDF output and give you some feedback.

Normally all pdf printers can print on any format even custom formats, hence the interest when you have only a small printer ...

So you have to give him the information if the desired size is not in stock ...

Put the correct DPI ... 600 mini



https://youtu.be/a-dIVfKNHKs