remove grip and modify segment
ginevra 03 Jul 2019
Hi you all,
I would like to remove a point of a polyline - a single grip, and I would like to modify the segment of this polyline, from right to arc.
How can I do it?
ps. similar to this: how can I do it in a hatch?
Thank you in advance!
V
I would like to remove a point of a polyline - a single grip, and I would like to modify the segment of this polyline, from right to arc.
How can I do it?
ps. similar to this: how can I do it in a hatch?
Thank you in advance!
V
Hellen_V 03 Jul 2019
Hi,
select the grip of polyline, then use CTRL button to remove, add vertex, make arc segment.
select the grip of polyline, then use CTRL button to remove, add vertex, make arc segment.
ginevra 03 Jul 2019
Hellen_V, on 03 July 2019 - 12:59 PM, said:
Hi,
select the grip of polyline, then use CTRL button to remove, add vertex, make arc segment.
select the grip of polyline, then use CTRL button to remove, add vertex, make arc segment.
Then... I am doing it but I don't get the functioning... should I click more times on CTRL to choice among remove/add/arc?
Sometimes the symbol disappears... maybe because the polyline was made with other software?
Hellen_V 11 Jul 2019
do you use nanoCAD 5 or other version?
Do you try to edit polyline or it is 2D- or 3D-polyline?
Do you try to edit polyline or it is 2D- or 3D-polyline?
Paolo Rossi 09 Dec 2019
Using nanocad 5.0, having a similar issue.
I select the grip, then press CTRL, but nothing happens.
Tried holding CTRL and selecting grip but that didn't work either.
I select the grip, then press CTRL, but nothing happens.
Tried holding CTRL and selecting grip but that didn't work either.
Paolo Rossi 09 Dec 2019
Paolo Rossi, on 09 December 2019 - 04:41 AM, said:
Using nanocad 5.0, having a similar issue.
I select the grip, then press CTRL, but nothing happens.
Tried holding CTRL and selecting grip but that didn't work either.
I select the grip, then press CTRL, but nothing happens.
Tried holding CTRL and selecting grip but that didn't work either.
This thread helped. PEDIT is a bit cumbersome, but it works.
http://forum.nanocad...ip-in-polyline/