Lines Tangent to Two Circles in Nanocad 8...
jmiller 06 Jul 2016
I understand by reading some older posts that Nanocad 8 will include options to draw lines tangent to two circles. Is this feature complete yet? And if so, how do I use it?
Hellen_V 08 Jul 2016
1. Create two circles
2. Call line, then switch on a tangent snap, select first circle.
3. Switch on a tangent snap again, select the second circle:
2. Call line, then switch on a tangent snap, select first circle.
3. Switch on a tangent snap again, select the second circle:
Attached Files
-
tangent.png (31.15K)
downloads: 19