Is it possible to set construction lines/rays at a pre-set angle? Also can they be used to bisect an angle?
Thanks,
Andrew McIntyre
0
Construction Lines & Rays
Started by Andrew McIntyre, Jun 23 2013 11:20 PM
2 replies to this topic
#1
Posted 23 June 2013 - 11:20 PM
#2
Posted 18 July 2013 - 08:43 AM
We made it for version 5.0, if you need a fix for 4.5 - I can send it to your.
Best regards,
Seva.
Best regards,
Seva.
#3
Posted 18 July 2013 - 02:33 PM
Just replace nCad.wld with attached one, then clear nanoCAD registry key
HKEY_CURRENT_USER\Software\Nanosoft\nanoCAD Eng\4.5
HKEY_CURRENT_USER\Software\Nanosoft\nanoCAD Eng\4.5
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users