In drawing units you can set the Base Angle and direction. This is normally set to East and Anticlockwise and works fine. But if you change this nothing happens.
With the default settings, if I draw a line: LINE 0,0 @100<30 it will draw correctly to the right at 30 degrees above the horizontal. If I go to units and change the base angle to North and the direction to clockwise, the same command should draw 30 degrees clockwise of the vertical. But it doesn't - it draws exactly the same as the default setting.
1
Units - base angle and direction don't work
Started by Russell Shannon, Jun 12 2019 03:32 AM
Units Base Angle Direction
2 replies to this topic
#1
Posted 12 June 2019 - 03:32 AM
#2
Posted 24 June 2019 - 01:48 PM
Hello Russel,
do you use nanoCAD 5? There was a bug with units, it is fixed in Plus/Pro versions.
do you use nanoCAD 5? There was a bug with units, it is fixed in Plus/Pro versions.
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
#3
Posted 04 July 2019 - 01:27 PM
On my Nanocad 5, the line moves to reflect the new orientation.
32 bit though, win 7.
32 bit though, win 7.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users