fillet
ginevra 14 Feb 2020
Hi you all,
I have a problem with the fillet command. Very often it doesn't work because "lines are not complanar". But if I see on the properties, both are on the same level. I also never draw in other plan than 2d. So, where am I wrong?
My version is nanocad 11 plus. Thank you
I have a problem with the fillet command. Very often it doesn't work because "lines are not complanar". But if I see on the properties, both are on the same level. I also never draw in other plan than 2d. So, where am I wrong?
My version is nanocad 11 plus. Thank you
ginevra 17 Feb 2020
ginevra 17 Feb 2020
do you prefer the attachment?
Here you can find it:
https://www.dropbox....ilievo.dwg?dl=0
thank you for your support!
Here you can find it:
https://www.dropbox....ilievo.dwg?dl=0
thank you for your support!
Kreator 17 Feb 2020
The reason is that the plines are in defferent planes. If you choose them both and look at Level property in Property window you'll see, that it says Different, despite they are both 0 if selected separately. Settin 0 Level for both will solve the problem. Maybe 1 of them is 0.0000000000001, that is shown as 0.0000.
ginevra 17 Feb 2020
Hi pguimber, thank you for your reply. The layer weren't locked, I uploaded fastly the file while I was working.
@Kreator, maybe your are right. How can I set for all of them the 0.0000 level?
Thank you so much!
@Kreator, maybe your are right. How can I set for all of them the 0.0000 level?
Thank you so much!
Kreator 17 Feb 2020
Select both plines, RMB, Properties (or Ctrl+1) - you'll see properties window. Find Level there and set 0.
ginevra 17 Feb 2020
thank you very much. You were wright, it works. Even if there is a 0 in the panel, maybe there is a tiny difference.
Thank you!
Thank you!
pguimber 17 Feb 2020
In NanoCad V5.... no problem ! Z all at 0,00, fillet is correct !
ginevra 17 Feb 2020
maybe 11 plus is more sensitive since v5 is only 2d? Don't know!
Anyway thank you too
Anyway thank you too