Modify properties
rfsmith48 22 Mar 2016
Hi,
New to Nanocad and the forum. I come from an Autocad background.
I haven't been able to figure out the command string to change the properties of an entity. I typically use this to change a line color, or move the line to a different layer.
Thanks,
Rog
New to Nanocad and the forum. I come from an Autocad background.
I haven't been able to figure out the command string to change the properties of an entity. I typically use this to change a line color, or move the line to a different layer.
Thanks,
Rog
Hellen_V 24 Mar 2016
Hello Rog,
that is not possible in nanoCAD, use Inspector.
We had added your wish to our wishlist.
that is not possible in nanoCAD, use Inspector.
We had added your wish to our wishlist.
rfsmith48 28 Mar 2016
Hi,
What is "Inspector"? I didn't find that in the Help topics...
What is "Inspector"? I didn't find that in the Help topics...
Hellen_V 28 Mar 2016
rfsmith48 29 Mar 2016
Thanks,
I found that dialog box and have been using it.
"Inspector" does not appear in the header, but that is not a problem.
Thanks again.
I found that dialog box and have been using it.
"Inspector" does not appear in the header, but that is not a problem.
Thanks again.
FloriN 25 May 2016
If you are searching for the equivalent of matchproperties from Autocad (that's what I understood from reading your post) then in nanoCAD you have COPYOBJECTPROPS (shortcut MA or MATCHPROP). If I understood wrong then I appologize. Regards!