1 reply to this topic

[Geoff]

Some notes about NanoCAD V5.0.2481.1466 - EVALUATION

• In the properties dialog for a selected viewport, under "Misc", "Stardard Scale" is mispelled ( "Standart Scale")
  
• The list of Standard scales in this dialog does not match the list of scales in the Measurement Scale dialog that is used to set the scale for dimensioning
  
  • This makes it difficult to choose a suitable scale for the viewport and then place correctly scaled dimensions
    
  • The list of scales should be the same, for example (1:4) in the propoerties dialog does not appear in the Measurement Scale dialog
    
  • Also (or alternatively), there should be an option to set a custom scale in the Measurement Scale dialog,
    
  • Also, after setting the Dimension scale it does not stay as the default, each time a new dimension is to be added in the viewport it reverts to 1:1. To get the correct dimension scale the dimension must be selected, then from the Dimension Scale dialog, choose the correct scale.
• These problems existed in Ver 4.5, it would be good to see them fixed in 5.0.

Geoff

[SevaM]

Hello Geoff,

thank you for your comments.

I'll try to fix mispelling, it's quite easy for interface part, but it seems it's also mispelled inside scale module.

I sent your suggestions about Measurement and Dimension scales to developer of this part of nanoCAD, for the 5.0 ( we already have Release Candidate version ) not sure, but probably in 5.1 coming soon.

Best regards,

Seva.