2 replies to this topic

[Steve Hennings]

When I use the Extend command, it no longer extends to the next object, but to apparently random points along the way. So I might have to clink the line 5, 10 or 20 times to get the line extended all the way to the next object. It seems to be specific to the file, as I can open a new document and it works normally. I used to run in to this problem with AutoCAD, but a redraw or regen would fix it, so far this hasn't worked in NanoCAD.

[Steve Hennings]

Update: it seems to work fine on new documents with only a few objects, but once the drawing starts to get more complicated I start having the problem and it gets progressively worse.

[SevaM]

Hello Steve,

could you send sample drawing and comments what object was used. Also, check snap settings - otner snap modes and size.

Best regards,
Seva.