I was looking around and found progeCAD which is very similar to nanocad. I don't know if they are based on open source software, but they sure looked very close with the exception that progeCAD can do 3D modeling which is what I would like to do. So will nanoCAD ever support 3D at all? I guess they're just similar but not the same.
https://www.youtube....h?v=xvT1ggEt0ME
1
Will nanocad support 3D modeling like progeCAD?
Started by Jaime, Jun 03 2013 08:19 AM
1 reply to this topic
#2
-
- Members
-
- 10 posts
Member
Posted 03 June 2013 - 04:45 PM
For anyone else looking for a free parametric program I found this one. I still like nanocad 2D, but I want to make some 3D parts. I don't know how well this will work, but I thought I share it here as well.
http://narocad.com/
It's been a while since I tried this one, so you can test it out too.
http://www.freecadweb.org/
I just found that I can use the delcam software too, so I'm now installing that one to see if I can make the small parts I want to draw in 3D. I'm trying to eventually make the actual parts, this is why I have been looking for something like this.
http://narocad.com/
It's been a while since I tried this one, so you can test it out too.
http://www.freecadweb.org/
I just found that I can use the delcam software too, so I'm now installing that one to see if I can make the small parts I want to draw in 3D. I'm trying to eventually make the actual parts, this is why I have been looking for something like this.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
