Hi everybody,
When using autocad I was used to create list of commands in excel and then paste them in the command prompt.Every cell contains a command and the "enter key" was automatic.
I tried to do the same with nanocad, but I can't obtain the same result. Any suggestion? Sorry for my bad English.
2
Enter key in command line
Started by Matteo Monti, Jun 28 2023 01:07 PM
1 reply to this topic
#1
Posted 28 June 2023 - 01:07 PM
#2
Posted 28 June 2023 - 06:10 PM
Hello, Matteo.
It's not clear - what goes wrong.
Can you, please, clarify a little: what did you do, what did you expected and what really happened?
Also, in NanoCAD when you use space in command line it considered as enter, so you can't use commands from, for example - two words separated by space.
p.s. Your English definitely isn't bad.
It's not clear - what goes wrong.
Can you, please, clarify a little: what did you do, what did you expected and what really happened?
Also, in NanoCAD when you use space in command line it considered as enter, so you can't use commands from, for example - two words separated by space.
p.s. Your English definitely isn't bad.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users