2 replies to this topic

[conti_rowland]

Hi,
I'm trying to create some complex lofts using plines.

I have 3 guides, one at either end and one in between.

I can get 2 of the guides at a time to be recognised but not all 3 and never both end guides.

I have tried to ensure that every pline has a corresponding geometry - in the sense that each is made of a similar number of curves and lines as I have previously had issues with that in Autocad.

Help please!

Andrew

[Artemio]

Hi.
I'm not sure if understand your issue correctly.
To draw precisely there is a good helper: Object snap and Polar tracking.
They can be settled in DSETTINGS dialog window.
If this is not what you need - can you, please, give a little bit more information?

[conti_rowland]

Hi there,

The issue was that the loft command did not work. The guides were not followed. It returned an error message.

In the end I found a solution by lofting the guides and using my original loft curves as guides!

Thanks
Andrew