4 replies to this topic

[Pedro Marcos Flores Refosco]

Greetings,

I'm pretty new on this subject. But when I started using Nanocad's Offset function, I noticed that when I type the distance, it presents me with a certain inaccuracy. I'm probably doing something wrong. I would like some guidance help. Remembering that I installed the software as instructed and started using it then, I didn't configure it in any way after installation.

Thank you for your time.

Pedro

[Artemio]

Hello.
Have you tried "help" section?
You can find it in top right corner of platform, looks like question mark, or type HELP in command line.
Then go to:
nanoCAD Platform - Editing Objects - Commands to edit and replicate objects - Offset.
Also it available here: https://online-help....&rhtocid=_9_3_3
It's quite good explanation, but if it won't help, please, write here, and we'll try to find what's happening.

[Artemio]

There are also good video guides (it's not about "offset" question, but maybe it'll be useful) via youtube channel: https://www.youtube....CADcom/featured

[Pedro Marcos Flores Refosco]

It did help. I was actually not following the right order input information. I don't understand why I was finding very close (but imprecise) results. But anyways, I followed the exact order of the inputs I need to give to the command (as shown here: https://www.youtube....CADcom/featured) and now it works properly. Thank you!

[Artemio]

You're welcome.