Hi
I`m using the free trial of v21.
I`m new to Nanocad and what I`m trying to achieve is for the Dim text to sit ON the Dim Line. I work on quite small drawings for engineering parts such as brackets etc. When I use the above option in the dim styles dialogue it seems to put the dimension quite a way above the line and not ON the line. I am zoomed in a lot as the lines are only 2 or 3 or so in length. Can I make the text sit lower in relation to the line as in Autocad ?
1
Dimension question New user
Started by Paul Morrey, Dec 04 2021 07:59 PM
4 replies to this topic
#1
Posted 04 December 2021 - 07:59 PM
#2
Posted 06 December 2021 - 06:10 PM
Hi.
When you call DIMSTYLE dialog -> modify -> Text
try not only the "Above", but also set "Offset from dim line".
It might be not 1, but also 0.01 for example.
When you call DIMSTYLE dialog -> modify -> Text
try not only the "Above", but also set "Offset from dim line".
It might be not 1, but also 0.01 for example.
#3
Posted 07 December 2021 - 08:42 PM
Hi
Thanks for the reply - I opened a dwg that I created in Autocad and then deleted the drawing itself and started a new drawing in the same window and my Dims seem a lot better.
When I get chance I will check out any differences in the dim style dialogue.
Thanks again.
Thanks for the reply - I opened a dwg that I created in Autocad and then deleted the drawing itself and started a new drawing in the same window and my Dims seem a lot better.
When I get chance I will check out any differences in the dim style dialogue.
Thanks again.
#4
Posted 08 December 2021 - 06:06 PM
Good luck!
And don't hesitate to ask here if you'll stuck.
And don't hesitate to ask here if you'll stuck.
#5
Posted 10 December 2021 - 07:43 PM
Thanks again for the response All the best
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users