3 replies to this topic

[Shane Mazur]

Hello, I am new to this so I'm sure I am just doing something wrong.

I made a drawing in AutoCAD and opened it in Nanaocad. From this point on I would like to use Nanocad exclusively but I am having 1 issue.

When I go to edit text and double click it opens up very spaced apart and makes it very hard to edit and see overtop of everything else drawn. When you leave the window it goes back to the correct spacing.

What am I missing, I would like the text to stay where it is so it is easy to edit. I have attached an example drawing. If you try to edit the following text in my drawing you will see what I mean.

"CONFIG GROUND
CONFIG POWER
CONFIG DATA
CONFIG CLOCK

AIRCRAFT PWR 1
POWER GROUND

AIRCRAFT PWR 2
POWER GROUND
SIGNAL GROUND
CDU SYS ID 1

CAN BUS LO"


Thanks in advance!!

Attached Files

•  LANCAIR-E2.dwg   95.45K   17 downloads

[pguimber]

Hello,
All the spaces must be erased between the words, as well as the spaces at the beginning of the text.
Spaces (Spacebar) are too wide in the text editor.

Cordialy
Patrick

[SummerEJohnson]

I was also facing the same issue and I am glad I have found my problem solution in your post.

[pguimber]