No replies to this topic

[Donald Culp]

I have a drawing (attached dxf) with several notes (otherwise called leaders) on a layer called "Leaders". The properties of these notes are set so that the line weight is by layer. In the Leaders layer the line weight is 0.8mm which should be quite heavy. These heavy weights don't show up on screen or printed. However, normal lines with heavier weights do show correctly.

In "\Tools\Settings parameters\Symbols\Notes\Mechanical note" I have tried setting Layer to Leaders and Line weight by Layer. These were saved to the document but have no effect. (As a test, setting Color to red in this menu also has no effect so I'm not sure that the parameters of this menu have any effect.)

In addition to changing the line weight I would also like to change the font weight.

Thanks for any suggestions,
Don C.

Attached Files

•  Line_tangent_to_circle_2pts_10c.dxf   109.87K   5 downloads