Hi everyone,
I recently just downloaded the free trial of nano cad. I only downloaded it to clean up a dxf file. I didnt realise at first but I did not register the account when installing. I spent about 4 hours fixing a dxf file and finally when I finished I went to save it. It comes up "for educational purposes only" when I try saving it. I am able to open the file on another dxf viewer but when I go to nest it onto my plasma table it doesnt seem to want to load. I'm assuming this is because there is some sort of lock on the file due to the account being for educational purposes only? If this is the case how do I go about registering the account after I have already installed it? Any help would be greatly appreciated! Thanks.
1
Registration after installation
Started by Chase Dexter, Dec 22 2020 03:04 AM
2 replies to this topic
#1
Posted 22 December 2020 - 03:04 AM
#2
Posted 22 December 2020 - 11:05 AM
Hello,
if it is urgent, send me your file (pguimberteau@gmail.com) otherwise wait for the nanoCAD Team to answer you.
Best regards
if it is urgent, send me your file (pguimberteau@gmail.com) otherwise wait for the nanoCAD Team to answer you.
Best regards
#3
Posted 22 December 2020 - 06:22 PM
Hello Chase,
could you please show screenshot of the "for educational purposes only" message?
could you please show screenshot of the "for educational purposes only" message?
nanoCAD Support Team
support@nanocad.com
support@nanocad.com
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users