Jump to content


How to set the default spline type as control vertices instead of fit?


1 reply to this topic

#1 memeac2006user

    Newbie

  • Members
  • Pip
  • 3 posts

Posted 11 November 2020 - 01:07 PM

I have been used to CV splines in my past experiences. In this software I have to refine every spline from fit to CV to suit my needs, I think that is too much work. Is there a way to set the default spline type to the control vertices type?

#2 Kreator

    Advanced Member

  • Members
  • PipPipPip
  • 144 posts
  • LocationKrasnodar, Russia

Posted 14 November 2020 - 01:41 PM

Hi.
In NC v20 you can use 2 separate commands to start CV or fit splines, or change there type in properties window after you finish spline.





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users