3 replies to this topic

[Evris Mitchell]

So guys. Doesn't NanoCAD allow us to trim rectangles? I select the cutting edges, right-click, attempt to select the side to cut and nothing happens. The process works fine with trimming lines and polylines. But when I try with rectangles, the side where I begin my two-point rectangle won't trim while the other sides trim. Very weird!

[pguimber]

Yes ! i can't reproduce this problem !

[Miguel]

I have the same problem.
I created a rectangle and an offset. When trying to trim it, the inner line (offset) is trimmed but the outerline is not.

It is just my first day of trying NanoCAD, so I wonder what else can I do to investigate the problem or what am I doing wrong...

Edit: Strangely enough, I created a new rectangle and an offset to it and I managed to trim that one. Undortunantely, it looks like we cannot paste pictures in here, so I cannot show both situations. I will move into a new rectangle and delete the one that does not work, but I wonder if this may happen again...

[Hellen_V]

Hi,

do you use nanoCAD 5? It can have some problems with Trim, try nanoCAD Plus.