lines of different thickness and that are perpendicular to each other are not trimmed properly
see picture
how can I ensure that the lines fit nicely?
(translated by Google Translate)
1
3 replies to this topic
#1
Posted 17 July 2020 - 04:57 PM
#2
Posted 18 July 2020 - 07:46 AM
Hello,
it is a question of display quality, normally in printing it should not be seen.
Thick lines are displayed with rectangular ends ....
c'est une question de qualité d'affichage, normalement à l'impression cela ne doit pas se voir.
Les lignes épaisses sont affichées avec des bouts rectangulaires....
Best regards
it is a question of display quality, normally in printing it should not be seen.
Thick lines are displayed with rectangular ends ....
c'est une question de qualité d'affichage, normalement à l'impression cela ne doit pas se voir.
Les lignes épaisses sont affichées avec des bouts rectangulaires....
Best regards
#3
Posted 20 July 2020 - 08:46 AM
When i print this drawing, i see the same overlapping lines
#4
Posted 20 July 2020 - 09:38 AM
Ok,i see !
but it's same in other CAO.
Otherwise it is necessary to make hatching in double lines ... or wipeout
but it's same in other CAO.
Otherwise it is necessary to make hatching in double lines ... or wipeout
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users