5 replies to this topic

[Adam Maoz]

Hi,
I'm trying to use NanoCAD to explode a block, but no block is recognized. However, when I double click the block, it does enter a referral editing mode for that block. What am I doing wrong?

I've attached the relevant file for reference.

Thanks,
Adam

Attached Files

•  explode.dxf   104.67K   33 downloads

[Vic]

Hi,

Try this

Add refedit toolbar (right click anywhere on toolbar / nanocadToolbars / select refedit

At refedit toolbar select / edit external references

Then you will be able to use explode

When finished use save and close external reference editing from refedit toolbar

[Adam Maoz]

No, it doesn't really help.

When I enter refedit, the elements seem separated and "exploded" and I can indeed use explode on them, but when I save and exit the editing of the refedit and click and piece, it seems "whole" again, as a block.

Any other ideas?

[pguimber]

Hello,
look the Properties-Obect type : Insert
save as dxf V11, close and open

look the Properties-Obect type : Block
You can edit and explode.
It is a typical object of external application (Covadis for example) which are very difficult to handle without the application.
It looks like this type of situation!

The trick in these situations is to see if going down to file versions solves the problem

Regards
Patrick

[Adam Maoz]

Thanks a lot!

[pguimber]