nanoCAD forum

Hi you all,

I would like to remove a point of a polyline - a single grip, and I would like to modify the segment of this polyline, from right to arc.

How can I do it?

ps. similar to this: how can I do it in a hatch?


Thank you in advance!

V

Hi,

select the grip of polyline, then use CTRL button to remove, add vertex, make arc segment.

Hellen_V, on 03 July 2019 - 12:59 PM, said:

first of all, thank you!

Then... I am doing it but I don't get the functioning... should I click more times on CTRL to choice among remove/add/arc?
Sometimes the symbol disappears... maybe because the polyline was made with other software?

do you use nanoCAD 5 or other version?
Do you try to edit polyline or it is 2D- or 3D-polyline?

comment withdrawn.

Using nanocad 5.0, having a similar issue.
I select the grip, then press CTRL, but nothing happens.
Tried holding CTRL and selecting grip but that didn't work either.

Paolo Rossi, on 09 December 2019 - 04:41 AM, said:

This thread helped. PEDIT is a bit cumbersome, but it works.

http://forum.nanocad...ip-in-polyline/