Jump to content


Dimension to 2 points


3 replies to this topic

#1 Donn Fishburn

    Newbie

  • Members
  • Pip
  • 7 posts

Posted 15 March 2019 - 05:28 PM

I have to believe this must have been addressed before but I cannot find it. I am experimenting with NanoCad to replace AutoCad. I am trying to place a dimension between the endpoints of 2 lines. I click on the horizontal dimension button but it does not allow me to select the end point. If I click on the line I get the aligned dimension of that line. I just need to be able to select points.

The drawing was originally created in AutoCad if that makes any difference.

#2 Hellen_V

    nanoCAD Team

  • Members
  • PipPipPip
  • 916 posts

Posted 19 March 2019 - 10:22 AM

Hello Donn,

what version of nanoCAD do you use? Make sure that Endpoint snap is selected.
nanoCAD Support Team
support@nanocad.com

#3 Donn Fishburn

    Newbie

  • Members
  • Pip
  • 7 posts

Posted 19 March 2019 - 11:06 PM

Version 5.0.2520.1471 Endpoint snap is on. I've also tried SHIFT+right click to select endpoint. It won't let me select the endpoint, only the line. I need to place a horizontal dimension between the endpoints of two lines.

#4 Hellen_V

    nanoCAD Team

  • Members
  • PipPipPip
  • 916 posts

Posted 21 March 2019 - 07:30 AM

can you send me the drawing? Attach it here, or send to Support Center support@nanocad.com
nanoCAD Support Team
support@nanocad.com





1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users