1 reply to this topic

[Jacuzi Jonson]

I have looked through the posts but haven't managed to find what is undoubtedly a very simple answer. So sorry if this has been covered before:

I wish for my grid to be in 1mm increments, with major lines at every 10mm, but all I can get is 10mm increments with major lines at every ten of those 10mm blocks. What am I doing wrong? In the TOOLS>DRAFTING SETTINGS,
I have had no luck with changes to the parameters. When I change grid x and Y spacing from 10 to 1, I get results such that a group of ten blocks now equals 110 mm??

Any thoughts would be helpful, thank you!

[Jacuzi Jonson]

I found the adjustment under TOOLS>SETTING PARAMETERS>DESIGN>MODEL SCALE, where I adjusted to ".1" so that the dimensions would read in millimeters rather than tens of millimeters.