←  nanoCAD forum

nanoCAD forum

»

Block Editor

Gabriele Cespuglio's Photo Gabriele Cespuglio 21 Oct 2016

Is there a way to set editor block in a trasparcy mode, like it was in the earlier version of Nanocad?
Quote

Hellen_V's Photo Hellen_V 07 Nov 2016

hello Gabriele,
what version do you use now? What block editor do you use - BEDIT or REFEDIT?
Quote

Gabriele Cespuglio's Photo Gabriele Cespuglio 17 Nov 2016

I use Nanocad 8 plus and BEDIT
Quote

Hellen_V's Photo Hellen_V 18 Nov 2016

Block Editor (BEDIT) edits block definition, and it can display only block elements, we made it specially.
You can edit block insertion with REFEDIT command, at this case other objects are visible and editable.
Quote

Gabriele Cespuglio's Photo Gabriele Cespuglio 18 Nov 2016

ok, thanks
Quote

Mark Pigott's Photo Mark Pigott 18 Jul 2017

So, when I am in BEDIT or REFEDIT, how do I adjust the insertion point?

That is the Blocks centre point, so to speak.
Quote

Hellen_V's Photo Hellen_V 19 Jul 2017

View PostMark Pigott, on 18 July 2017 - 03:04 PM, said:

So, when I am in BEDIT or REFEDIT, how do I adjust the insertion point?

That is the Blocks centre point, so to speak.
Hi Mark,
explode the block and create new one with the same name and other insertion point.
Quote