←  nanoCAD forum

nanoCAD forum

»

Decimals of degrees

Jason Hubbell's Photo Jason Hubbell 02 Mar 2016

Hello,

I have a question regarding the degrees which lines and objects are expressed as.

Is it possible to express them with decimals? I only ever see whole numbers expressed. When I try and change a line from say 11 degrees to 11.2 degrees the .2 is always left off. I don't know if it is just not being shown but is 11.2 degrees or if it just isn't possible to use fractions of degrees.

If it is just not being shown is there an option with which the line will be expressed as 11.2 in the properties?

Thank you for the support.
Quote

Hellen_V's Photo Hellen_V 02 Mar 2016

Hello Jason,

you should open Units dialog and change the precision of decimal degrees.
Quote

Jason Hubbell's Photo Jason Hubbell 02 Mar 2016

AH yes...thank you...adjusted properly now.
Quote