nanoCAD forum

when i use copy command with dimensions it becomes larger like that itis scaled ...is there a solution?

Hello,

which dimension was used and in which mode you had started Copy command.

I had try to reproduse problem - but my dimesion is the same after Copy

Hello, I also had this problem when the Layer = 0,
the dimension changes.

Nayara Ferreira, on 17 September 2015 - 11:36 AM, said:

Hello,
can you send us one of your file with this problem?

The following file attached.

This only happens in version 5.0, in version 7.0 is OK.

now attached hehehe

I thought the problem was with the layer 0,
but with the current layer.

Yes, it was the problem with copy on the current layer.
Problem is fixed in a 6 version