I start to use nanocad for drawing.
I saw that circle are plot as polygon as output PDF is not clear.
I have some logo and the result in PDF is not clean.
Here is an example of what I get:
Is it a way to improve the output ?
Thanks for your support
2
Circle plot as polygon
Started by Elen Glimois, Feb 10 2020 10:49 PM
3 replies to this topic
#1
Posted 10 February 2020 - 10:49 PM
#2
Posted 11 February 2020 - 02:57 PM
Hello,
if you use the pdf printer of nanocad you can also use other pdf printer , Pdfcreator and similar. what résult ?
if you use the pdf printer of nanocad you can also use other pdf printer , Pdfcreator and similar. what résult ?
#3
Posted 11 February 2020 - 03:06 PM
I done it with Bullzip printer (it was the only PDF printer to have ARCHD format - ie 36x24 po).
Is it possible to add this format to the internal PDF printer (I tried but I failed) ? If is it possible I would be able to test on other PDF output and give you some feedback.
Is it possible to add this format to the internal PDF printer (I tried but I failed) ? If is it possible I would be able to test on other PDF output and give you some feedback.
#4
Posted 11 February 2020 - 05:02 PM
Normally all pdf printers can print on any format even custom formats, hence the interest when you have only a small printer ...
So you have to give him the information if the desired size is not in stock ...
Put the correct DPI ... 600 mini
https://youtu.be/a-dIVfKNHKs
So you have to give him the information if the desired size is not in stock ...
Put the correct DPI ... 600 mini
https://youtu.be/a-dIVfKNHKs
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users